Harbor Freight Tools Riding Toy 38137 User Manual

Item #38137 Steel Flat Rack Wagon

Assembly and Operating Instructions

3491 Mission Oaks Blvd., Camarillo, CA 93011

this manual or any artwork contained herein may be reproduced in any shape

or form without the express written consent of Harbor Freight tools.

For technical questions and replacement parts, please call 1-800-444-3353.

Thank you for choosing a Harbor Freight Tools product! For future reference, please complete the owner’s

record befow:

Model:___________________

Purchase Date:_________________

Save the receipt and these instructions. It is important that you read the entire instruction sheet to become

familiar with this product before you begin using it.

Technical Specifications:

Capacity: 1000 lbs.

Wagon Deck: 4’long, 2’wide

Wheels: Steel Hubs with Bearings

Steering: Steel Handle and Steering Mechanism

Assembly and Operating Instructions

Some assembly is required as described below. Refer to the parts diagram and part number listing on the

reverse side of this page when performing assembly operations.

1. Turn the Tray (B) upside down so that the exposed screw holes can be seen.

2. Attach the Rear Bracket (C) to the Tray using two Bolts (M8x38)-for connection of the main axle portion of

the Rear Bracket, and four Bolts (M6x20)-for connection of the support arms of the Rear Bracket. All bolts

receive both a Spring Washer, Flat Washer, and Nut.

3. Attach the Turning Bracket (D) to the Tray using two Bolts (M8x38)-for connection of the main axle portion

of the Turning Bracket, and two Bolts (M6x20)-for connection of the front portion of the Turning Bracket. The

rear portion of the Turning Bracket is attached to theTray with 2 Bolts (M6x20). All bolts receive a Spring

Washer, Flat Washer and a Nut.

4. Attach the Handle (E) to the Turning Bracket by using Bolt (M6x63), Spring Washer, Flat Washer and Nut.

5. Install the four Wheels (F) by placing each wheel on the axle portion of the Turning Bracket and the Rear

Bracket. Secure each Wheel with a Flat Washer (M16) and a Split Pin (M3x30).

REV 05/05

Item #38137

Page 1